Image Description -  0713-3

A black and white figure shown in perspective view is captioned 
"Figure 3. Fitting Master Tool to Transfer Gauge".  The figure 
shows a partial cross section of two circular flanges. One flange 
is the transfer gauge described in the previous figure.  A smaller 
flange called "Mastered Tool (Drill Jig)" is positioned concentric 
to the transfer gauge. The outside diameter of the mastered tool 
is smaller than the outside diameter of the transfer gauge.  Three
thru holes drilled on equal radii.  The three holes on the mastered 
tool contain potted bushings, which are installed using a potting 
pin.  A check pin is also shown which is used to verify the exact 
location of each hole.